Steering Column, Removing And Installing: Installing

Installation Is The Reverse Of Removal, With Special Attention To The Following:

• If the steering column on a vehicle with the steering locking system was replaced, use the bolt installed in the new steering column. Refer to -item  ) OVERVIEW - STEERING COLUMN - BOLT for the Electronic Steering Column Lock Control Module -J764-.

Tightening specifications. Refer to OVERVIEW - STEERING COLUMN .

-- Clean the threaded hole (for example, using a thread tap) before installing the new bolt -2-.

Applies to Vehicles with the Steering Lock Lock-Up System 

• After re-connecting the connector, -2- make sure the wiring harness -3- is secured by the clip -5-.
• If the steering column needs to be adjusted, be careful not to pinch the wiring harness -3- for the Electronic Steering Column Lock Control Module -J764- -1- and make sure it does not come in contact with any sharp edges.

Follow the Assembly Sequence when Installing. 

-- Position the steering column with the positioning pins -1- in the positioning holes on the central tube.

-- Install the driver side right knee bar loosely with the bolt -4-, if equipped.

-- Install all bolts loosely.

-- First tighten the bolt -2- to the tightening specification.

-- Then tighten the bolt -3- to the tightening specification.

-- Then tighten the bolt -4- and bolt -5- to the tightening specification.

-- Then tighten the bolt -6- and bolt -7- to the tightening specification.

-- Tighten the bolt -8- and bolt -9- to the tightening specification.

-- Replace the spring nut -10- if the steering column was replaced.

-- Install the steering intermediate shaft -3- on the steering column -1- as far as the stop and tighten the bolt -2-.

-- Install The Steering Column Switch Module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING ) .

-- Install The Steering Column Trim Panels. Refer To UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING / LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Install The Footwell Vent On The Driver Side. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING / OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN PASSENGER COMPARTMENT .

-- If Equipped, Install The Driver Side Knee Airbag. Refer to KNEE AIRBAGS / KNEE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .

-- Install The Driver Side Instrument Panel Cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Install the airbag steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .

-- Install The Driver Airbag. Refer To DRIVER SIDE AIRBAG and FRONT SIDE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .

-- After replacing the Electronic Steering Column Lock Control Module -J764-, the module must be adapted to the immobilizer.

-- Connect the Vehicle Diagnostic Tester and begin vehicle-specific entry into Guided Functions.

-- Select the corresponding program in "Guided Functions".

-- Follow the prompts on the screen.

-- The Steering Angle Sensor -G85- must be calibrated after installing the steering column switch module.

-- Connect the Vehicle Diagnostic Tester and begin vehicle-specific entry into Guided Functions.

-- Follow the prompts on the screen.