Torque Support And CROSSMEMBER, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
Tightening specifications:
- Refer to OVERVIEW - TORQUE SUPPORT .
NOTE:
Replace any bolts that were tightened with an additional turn.
Remove the subframe bolts one after the other and replace them.
-- Install the crossmember and the subframe, refer to OVERVIEW - SUBFRAME, CROSSBRACE, STABILIZER BAR, COUPLING ROD AND SUBFRAME SHIELD .
-- Fill with coolant, refer to COOLANT, DRAINING AND FILLING => Filling .
-- Install the noise insulations, refer to OVERVIEW - NOISE INSULATION .
-- Install the right front wheel housing liner, refer to WHEEL HOUSING LINER .