LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2013 >> S8 >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> 4.0L - Generic Scan Tool - Engine Code(S): CEUA & CGTA (1 Of 2) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My 2012-2014) >> Monitor-ID $A9 : Mis-Fire Cylinder 8 Data

Monitor-ID $A9 : Mis-Fire Cylinder 8 Data

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID $A9".

-- Select the desired "Hex-ID".

-- Check specified values at idle.

(Hex-ID) DTC Component or System Min. Max. Additional Information
$0B P0308 Average value over 10 DCYs 0 cnts 65535.0 cnts Refer to DTC P0308 in the DTC table. Engine Control Module --, 2012-2014 MY => P0304 .
$0C P0308 Combustion misfires in this DCY 0 cnts 65535.0 cnts Refer to DTC P0308 in the DTC table. Engine Control Module --, 2012-2014 MY => P0304 .

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

-- If any of the components or systems fail to meet the specified values, refer to Diagnostic Mode 03: Interrogating Fault Memory to check for stored DTCs or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

scientia non olet · About LEMON Manuals