Rearview Camera System Control Module -J772-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL (Sedan) or LUGGAGE COMPARTMENT SIDE TRIM PANEL (Wagon) .

The bracket must be removed first in order to be able to remove the Rearview Camera System Control Module -J772-. It is attached with screws to the relay and fuse panel F inside the luggage compartment on the right side. The relay and fuse panel F in the luggage compartment on the right side must first be removed. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL (Sedan) or LUGGAGE COMPARTMENT SIDE TRIM PANEL (Wagon) .

Removing the bracket

-- Unlock and disconnect all of the connectors from the control modules.

-- Remove the nuts -arrows- and remove the bracket -1- along with the control modules from the luggage compartment recess.

Fig 1: Removing Nuts -Arrows- And Remove Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

The Rearview Camera System Control Module -J772- -1- is only clipped into the bracket -2-.

Fig 2: Disconnecting Connectors From Rearview Camera System Control Module -J772- -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors from the Rearview Camera System Control Module -J772- -1-.

-- Press the retainer downward and remove the Rearview Camera System Control Module -J772- -1- from the bracket -2-.