LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2013 >> S6 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> 4.0L - Generic Scan Tool - Engine Code: CEUC >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My-2015) >> Monitor-ID ($3D): EVAP Valve Function Check

Monitor-ID ($3D): EVAP Valve Function Check

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID ($3D)".

-- Select the desired "Hex-ID".

-- Check specified values at idle.

(Hex-ID) DTC Component or System Min. Max. Additional Information
$80 P0441 Tank vent valve check, Active test Air balance at idle OK. 0.200012 1.999 Refer to DTC P0441 in Engine Control Module --, 2015 MY
$88 P0441 Tank vent valve check, Active test, Oxygen sensor deviating in lean direction (can only test OK). 1.0 (counts) 65535 (counts)

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals