Engine Coolant Temperature Sensor -G62- Connector Assignment
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
-- Disconnect the 2-pin connector on Engine Coolant Temperature (ECT) Sensor. Refer to FOR ENGINE CPNB - ENGINE COOLANT TEMPERATURE SENSOR -G62-, REMOVING AND INSTALLING , FOR ENGINE(S) CTUA & CGXB - ENGINE COOLANT TEMPERATURE SENSOR -G62-, REMOVING AND INSTALLING or FOR ENGINE(S) CEUC & CRDB - ENGINE COOLANT TEMPERATURE SENSOR/ENGINE TEMPERATURE CONTROL SENSOR -G62- / -G694-, REMOVING AND INSTALLING - sensor is not removed.
Terminal assignment of the 2-pin harness connector at Engine Coolant Temperature (ECT) Sensor
- Sensor ground (GND)
- Wire connection from Engine Coolant Temperature (ECT) Sensor to engine control module