Technical Data: Capacities
ATF area in the transmission
| Capacities | Multitronic 0AW |
|---|---|
| Original filling by the manufacturer | Refer to Fluid Capacity Tables |
| Change |
|
| Lubricant | For the correct ATF for the "Multitronic 0AW FWD" |
CAUTION:
Danger of causing damage to the transmission.
- For the correct allocation of the ATF . Only use replacement part ATF for "Multitronic 0AW FWD" for the "Multitronic 0AW FWD" transmission.
- Do not mix other ATF types, even in small quantities. Malfunctions and transmission failure could occur.
- Check the ATF level and correct if necessary, refer to ATF LEVEL, CHECKING .
- ATF, Draining and Filling, refer to ATF, DRAINING AND FILLING
Front Final Drive
| Capacities | Multitronic 0AW |
|---|---|
| Initial filling | Approximately 1.1 liters |
| Change |
|
| Lubricant |
|
CAUTION:
Danger of causing damage to the transmission.
- There are different gear oils for the "Multitronic 0AW transmission".
- Only gear oil available as a replacement part meant for the transmission code may be used.
- Do not mix the axles oil, not even in small quantities. This will cause the sealing rings to leak. Note the allocation of the axle oils according to the transmission code letters . Only axle oil for "Multitronic 0AW" which can be obtained as a replacement part must be used in front final drive.
- Replace the filler plug after checking the level. Always pay attention to the allocation according to the transmission codes . Compare the old and new filler plug to prevent leakage on the transmission.
- Do not mix other gear oils, even in small quantities. Leaks in the transmission will result.
- Checking and filling the gear oil level in the front final drive, refer to GEAR OIL, CHECKING LEVEL .
- Fill the front final drive with gear oil after the repair, refer to GEAR OIL, DRAINING AND FILLING .