LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2013 >> A4 Base >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> 2.0L - Generic Scan Tool - Engine Code(S): CPMA & CPMB (1 Of 2) (Sedan) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My 2015) >> Monitor-ID 3D ($3D): EVAP Valve Function Check

Monitor-ID 3D ($3D): EVAP Valve Function Check

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID 3D ($3D)".

-- Select the desired "Test-ID (TID)".

-- Check specified values at idle.

Test-ID (TID) DTC Component or System Min. Max. Additional Information
$80 P0441 Tank vent valve check from % DTEV: Active test Air balance at idle OK, (Normal operation and short test 70). 0.300 % 1.999 % Refer to DTC P0441 in the DTC summary table.Engine Control Module --, 2015 MY => P0441
$88 P0441 Tank vent valve check from % DTEV: Active test, Oxygen sensor regulator deviating in lean direction (can only test OK), (Normal operation and short test 70). 1.0 % 65, 535 % Refer to DTC P0441 in the DTC summary table.Engine Control Module --, 2015 MY => P0441

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Ignition switched OFF.

scientia non olet · About LEMON Manuals