Brake Pedal: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the bolt and nut which secure the brake pedal bracket.
Tightening torque:

18 N.m (1.84 kgf-m, 13.3 ft-lb)
Install clevis pin and snap pin which secure the operating rod to the brake pedal.
NOTE:
- Replace with a new clevis pin.
- Apply a thin coat of KOPR-KOTE (Part No. 003603001) to the clevis pin.
  
  Fig 1: Clevis Pin, Snap Pin, Brake Pedal And Operating Rod
  Courtesy of SUBARU OF AMERICA, INC.
Connect the stop light switch connector.
Check that the brake light operate properly.
Check the brake pedal after installation. < Ref. to INSPECTION , Brake Pedal . >