Diagnostic Mode 01: Obtain Data
WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostic Mode 01 is used to display and monitor all emissions related measured values.
Test requirement
- Coolant temperature at least 80°C.
Procedure
- Connect the diagnostic tester.
- Start the engine and run at idle.
- Select "Diagnostic Mode 1: Obtain data.".
- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID 05-Coolant temperature".
NOTE:
- More than one "PID" may be selected and monitored.
The current values of the component or system that is being monitored will be displayed on the diagnostic tester screen.
| PID | Component or System |
|---|---|
| 01: | Monitoring status since erasing DTC memory |
| 03: | Condition of fuel system |
| 04: | Calculated load condition value |
| 05: | Coolant temperature |
| 06: | Short term gasoline-air ratio bank 1 |
| 07: | Gasoline-air ratio bank 1 |
| 12: | Engine rotations per minute (RPM) |
| 13: | Vehicle speed |
| 14: | Ignition timing adjustment at 1. cyl. in direction |
| 15: | Intake air temperature (IAT) |
| 16: | Air flow quantity at Mass Air Flow (MAF) sensor |
| 17: | Throttle valve position (absolute) |
| 19: | Existing oxygen B1 to B2-S2 to (exist./nonexist.) |
| 21: | Bank 1 - sensor 2 |
| 28: | OBD request is designed for diagnostic of this vehicle |
| 31: | Time after engine on |
| 33: | Driven distance after MIL on |
| 35: | Fuel Rail Pressure |
| 46: | Commanded Evaporative Purge |
| 48: | Number of warm ups since diagnostic trouble codes |
| 49: | Distance since diagnostic trouble codes cleared |
| 51: | Barometric Pressure |
| 52: | Bank 1 - sensor 1 |
| 56: | Bank 2- sensor 1 |
| 60: | Catalyst Temperature Bank 1, Sensor 1 |
| 65: | Monitor status this driving cycle |
| 66: | Control module voltage |
| 67: | Absolute Load Value |
| 68: | Commanded Equivalence Ratio |
| 69: | Relative Throttle Position |
| 70: | Ambient air temperature |
| 71: | Absolute Throttle Position B |
| 73: | Accelerator Pedal Position D |
| 74: | Accelerator Pedal Position E |
| 76: | Commanded Throttle Actuator Control |
- Switch the ignition off.
- End of diagnosis.