Rearview Camera System: Removal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not drop or apply any impact to the rearview camera because it is a precision equipment.
When removing the rearview camera, remove the screws located at the specified position only. Do not remove the screws attaching the bracket. Removing them will decrease the rearview camera attaching force.

Fig 1: Locating Rearview Camera System Screws
Courtesy of SUBARU OF AMERICA, INC.

Disconnect the ground cable from battery.
Remove the rear gate trim. < Refer to REMOVAL , Rear Gate Trim >
Remove the rear wiper motor. < Refer to REMOVAL , Rear Wiper Motor >
Remove the rear gate garnish. < Refer to REMOVAL , Rear Gate Garnish >
Remove the rearview camera assembly.
1. Disconnect the connector.
  
  Fig 2: Locating Rearview Camera Assembly Connector
  Courtesy of SUBARU OF AMERICA, INC.
2. Pull out the harness, and then remove the screws.
  
  Fig 3: Locating Rearview Camera Assembly Screws
  Courtesy of SUBARU OF AMERICA, INC.
3. Rotate the camera harness to remove the rearview camera.
  
  Fig 4: Rotating Camera Harness
  Courtesy of SUBARU OF AMERICA, INC.