Ignition Coils

Special tools and workshop equipment required

Removing

Fig 1: Ignition Coil Connectors - Tightening Specification

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -6- from Camshaft Position (CMP) sensor 3 -G300-.

-- Remove the bolts -arrows-.

-- Release the connectors and remove them from the ignition coils -1 through 5-.

-- Push the T40039 onto the ignition coil with power output stage and remove the ignition coil -arrow-.

Fig 2: Identifying Ignition Coil Puller T40039 To Remove Ignition Coils

Courtesy of AUDI OF AMERICA, LLC

Installing

-- Install all the ignition coils loosely into the spark plug shaft.

-- Align and connect the ignition coils to the connectors all at the same time.

-- Push the ignition coils evenly onto the spark plugs by hand (do not use a hammer).

-- Attach the ignition coil wiring guide to the cylinder head cover. Refer to Figure.