Navigation Connector Assignment (Japan)
- Not Assigned
- Connection block with four multipin connectors
- MOST Bus
- CVBS input (Green) from the TV Tuner -R78-
- 4-pin connector (T4am) for the Front Information Display Control Head -J685-
- 4-pin connector (T4ap) to External Audio Source Connection -R199-
- Not Assigned
- Antenna Connection (GPS) from the Roof Antenna -R216-
NOTE:
Unlisted connector terminals are not assigned.
2 - Connection block with four multipin connectors
- Not Assigned
- Power Supply to Multimedia System Control Head -E380-
- Wake UP to Multimedia System Control Head -E380-
- Not Assigned
- Switch on signal from Chip Card Reader Control Module -J676-
- Reset to the Multimedia System Control Head -E380-
- Ring-break Diagnostic Cable
- Not Assigned
- Microphone IN (+) for the Microphone Unit in Front Roof Module -R164- (Right Front Microphone -R141-)
- Microphone IN (-) for the Microphone Unit in Front Roof Module -R164- (Right Front Microphone -R141-)
- VICS data to Chip Card Reader Control Module -J676-
- CVBS cable (-) for the Rearview Camera System Control Module -J772-
- ETC data to Chip Card Reader Control Module -J676-
- Not Assigned
- Microphone IN (+) for the Microphone Unit in Front Roof Module -R164- (Left Front Microphone -R140-)
- Microphone IN (-) for the Microphone Unit in Front Roof Module -R164- (Left Front Microphone -R140-)
- VICS data from the Chip Card Reader Control Module -J676-
- CVBS cable (+) for the Rearview Camera System Control Module -J772-
- ETC data from the Chip Card Reader Control Module -J676-
All pins are connected to the External Audio Source Connection -R199-.
- LF-In ground
- Right LF-In
- USB (+5V)
- USB (ground)
- Not Assigned
- Detect
- Left LF-In
- LF-In ground shielding
- CVBS cable (+)
- CVBS cable (-)
- iPod data
- iPod data
10 -
Data from Multimedia System Control Head -E380-
11 -
Data to the Multimedia System Control Head -E380-
12 -
Terminal 31
14 -
Reset from Multimedia System Control Head -E380-
15 -
Terminal 30
16 -
Ground to Multimedia System Control Head -E380-
- Input
- Output