LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A8 Base >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> 4.2L - Generic Scan Tool - Engine Code: CDRA (1 Of 2) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions >> Monitor-ID $A2 (162) : Mis-Fire Cylinder 1 Data

Monitor-ID $A2 (162) : Mis-Fire Cylinder 1 Data

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID A2".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min./Max. Values Additional Information
11 ($0B) P0301 Misfire cylinder 1, Average value over 10 Driving Cycles. 0 - 65535 (counts) Refer to DTC P0301 in the DTC summary table. Engine Control Module --, 2010-2012 => P0301 .
12 ($0C) P0301 Misfire cylinder 1, in this Driving Cycle. 0 - 65535 (counts) Refer to DTC P0301 in the DTC summary table. Engine Control Module --, 2010-2012 => P0301 .

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals