Electromechanical Steering Gear, Removing And Installing: Notes
Special Tools And Workshop Equipment Required
- Puller - Ball Joint T40010A
- Torque Wrench 1331 5-50 Nm VAG 1331
- Torque Wrench 1332 40-200 Nm VAG 1332
- Torque Wrench 1332 Insert - Ring Wrench - 21mm VAG 1332/7
NOTE:
Power steering gear is completely removed and installed with tie rods.
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and installing on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.