Ignition System Overview
- 1 -
Ignition Coil Connector
- 4-pin
- 2 -
Bolt
- 10 Nm
- 3 -
3-Pin Connector
- 4 -
Camshaft Position Sensor
- Camshaft Position Sensor -G40- (cylinder bank 1)
- Camshaft Position Sensor 3 -G300- (cylinder bank 1)
- Camshaft Position Sensor 2 -G163- (cylinder bank 2)
- Camshaft Position Sensor 4 -G301- (cylinder bank 2)
- Removing and installing, refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING
- 5 -
O-Ring
- Replace if damaged
- Coat with clean engine oil
- 6 -
Bolt
- 20 Nm
- Tightening specifications affect the function of the knock sensor
- 7 -
Knock Sensors
- Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
- Knock Sensor 1 -G61- (cylinder bank 1)
- Knock Sensor 2 -G66- (cylinder bank 1)
- Knock Sensor 3 -G198- (cylinder bank 2)
- Knock Sensor 4 -G199- (cylinder bank 2)
- Removing and installing, refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING
- 8 -
Spark Plug
- Removing and Installing using Spark Plug Removal Tool 3122B, refer to => 410 Spark Plugs, Replacing.
- 9 -
Ignition Coil
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Ignition Coil 5 with Power Output Stage -N323-
- Ignition Coil 6 with Power Output Stage -N324-
- Ignition Coil 7 with Power Output Stage -N325-
- Ignition Coil 8 with Power Output Stage -N326-
- Removing and installing, refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING