Checking wiring

-- Remove the Engine Control Module - J623 -. Refer to appropriate Service Information.

-- Using a Multimeter, Check the Low Fuel Pressure Sensor -G410- electrical harness connector to the Engine Control Module - J623 - electrical harness connector T60 for an open circuit.

Specified value: 1.5 Ω Max.

If the specified value was Not obtained:

-- Check the wiring connection for an open circuit or short circuit.

-- Check the wiring connection for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Go to Final procedures.

If the specified value was obtained:

-- Replace the Engine Control Module - J623 -. Refer to appropriate Service Information.

-- Go to Final procedures.

-- Remove the Engine Control Module - J623 -. Refer to appropriate Service Information.

-- Using a Multimeter, Check the Low Fuel Pressure Sensor -G410- electrical harness connector to the Engine Control Module -J623 - electrical harness connector T94 for an open circuit.

Specified value: 1.5 Ω Max.

If the specified value was Not obtained:

-- Check the wiring connection for an open circuit or short circuit.

-- Check the wiring connection for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Go to Final procedures.

If the specified value was obtained:

-- Replace the Low Fuel Pressure Sensor -G410-. Refer to appropriate Service Information.

Final procedures 

-- Reinstall the engine cover with air filter, if necessary. Refer to the appropriate Service Information.

-- After the repair work, the following work steps must be performed in the following sequence:

After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
2. If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
3. If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .