Drive Axle Threaded Connection
Special Tools And Workshop Equipment Required
- Torque Wrench 80-400 Nm VAG 1576
Loosen the threaded connection between the drive axle and wheel hub.
-- With vehicle still standing on its wheels, loosen bolt a maximum of 90°, otherwise wheel bearing will be pre-damaged.
-- Place the vehicle on a hoist, refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .
-- Lift the vehicle just enough so that the wheels are hanging free.
-- Apply the brakes (a second technician required).
-- Remove the bolt -arrow-.
Tighten the threaded connection between the drive axle and wheel hub.
-- Replace the bolt -arrow-.
Before installing, clean the threads in the CV joint with a tap.
Wheels must not yet touch the ground to tighten the drive axle, wheel bearing may otherwise be damaged.
-- Apply the brakes (a second technician required).
-- Tighten bolt to 200 Nm.
-- Lower the vehicle onto its wheels, refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .
-- Tighten bolt an additional 180°.