LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A8 Base >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Fuel System >> 4.2L - Generic Scan Tool - Engine Code: CDRA (1 Of 2) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions >> Monitor-ID $36 (54) : Cam shaft adjustment / IVVT-Diagnose Bank 2

Monitor-ID $36 (54) : Cam shaft adjustment / IVVT-Diagnose Bank 2

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID 36".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min. Max. Additional Information
128 ($80) P0021 VVT diagnosis target position not reached 3° 22° Refer to DTC P0021 in the DTC summary table. Engine Control Module --, 2010-2012 => P0021
129 ($81) P000C VVT diagnosis target position reaches Slow Response 8° 63° Refer to DTC P000C in the DTC summary table. Engine Control Module --, 2010-2012 => P000C
130 ($82) P0024 VVT diagnosis target position not reached 3° 20° Refer to DTC P0024 in the DTC summary table. Engine Control Module --, 2010-2012 => P0024
131 ($83) P000D VVT diagnosis target position reaches Slow Response 8° 63° Refer to DTC P000D in the DTC summary table. Engine Control Module --, 2010-2012 => P000D

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals