Brake Pressure Sensor 1 -G201-: Installing

Installation is in reverse order of removal, with special attention to the following:

-- Bleed the brake system.

-- Bleed the clutch hydraulic system. Refer to [For transmission(s) 02Q] General Information

-- Initiate the calibration of the sensor -1- for brake pressure sensor 1.

-- Perform the ESP driving and system tests.

Use the vehicle diagnosis, testing and information system VAS 5051 B or VAS 5052.

-- Connect the vehicle diagnosis, testing and information system VAS 5051 B or VAS 5052 and select a function.

-- Under chassis

-- Brake system (Repair Group 01; 45)

-- 01- On Board Diagnostic (OBD) capable systems

-- 03- Brake electronics ABS/ESP Mark 60

-- J104- ABS/ASR/ESP Control Module, Functions

-- Calibrate brake pressure sensor 1