ATEQ TPMS Reset Procedure
NOTE:
On Audi vehicles, the TPMS3 cannot be used to register the TPMS sensors, or reset the TPMS.
NOTE:
In order for the TPMS to work, the specified pressures (provided on tire pressure label) must be reprogrammed after every change in air pressure.
NOTE:
Whenever tire pressure is adjusted (i.e., when readjusting tire pressure for a load condition), or after every wheel change, the adjusted pressure has to be stored again.
NOTE:
The correct saving of the specified values is a basic requirement for accurate tire pressure monitoring.
- Adjust air pressure in all tires to specifications (provided on tire pressure label located inside fuel filler door/B pillar).
- Turn ignition ON.
- Vehicle must be stationary.
- Press the TIRE PRESSURE MONITORING button, on the center console, for approximately 5 seconds or until a signal tone is heard and the YELLOW malfunction light in the instrument cluster flashes several times, this confirms the calibration procedure.