Test-ID 05 ($05): Oxygen Sensor in front of Catalytic Converter Bank 2 - Sensor 1
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 05 ($05)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 08($08) | P0152 | Signal Activity Check. | 450 mV | 1300 mV | Refer to DTC P0152 in Fuel and air ratios . |
| 09($09) | P0153 | Response Check. | --- | 0.3 Seconds | Refer to DTC P0153 in Fuel and air ratios . |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.