Diagnostic Mode 09 - Vehicle Information
WARNING: This page is about a different variant/trim than selected.
NOTE:
- For all calibration and immobilizer information.
Diagnostic Mode 09 is used to display vehicle specific information, e.g. the different Engine Control Module (ECM) versions.
NOTE:
- Depending on scan tool and protocol used, diagnostic mode 09 and the information provided may be referred to by a different name.
Test requirement
- No DTCs stored in the DTC memory.
Procedure
- Connect the scan tool.
- Switch the ignition on.
- Select "Mode 09: Vehicle information".
- Select the desired "Test-ID".
- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all "Test-IDs" that may be selected.
| Test-ID | Diagnostic text |
|---|---|
| 02: | Vehicle identification number e.g. |
|
|
| 04: | Calibration identification e.g. |
|
|
|
|
| 06: | CVN (check sum) e.g. |
|
|
|
|
| 08: | In Use Performance Tracking |
- Switch the ignition off.
- End of diagnosis.