Diagnostic Mode 08 - Tank Leak Test
Diagnostic Mode 08 is used to determine if the fuel system is leaking.
Depending on the scan tool being used, the function test in Diagnostic Mode 08 may or may not be able to be performed.
If the scan tool being used will operate Diagnostic Mode 08, perform the test below.
NOTE:
- Always follow the manufacturers instructions for the scan tool being used.
Test requirements
- No DTCs stored in the DTC memory.
- Intake Air Temperature (IAT) maximum 60 C.
- Coolant temperature 80 -110 C.
- Throttle valve angle 12.0 - 16.0%.
Function test
NOTE:
- If the accelerator pedal is depressed during the test, the test will be aborted.
- Connect the scan tool.
- Start the engine and run at idle for at least 15 minutes.
- Select "Diagnostic Mode 08 - Tank Leak Test".
- Select " Tank Leak Test".
- Check the specified value of the tank leak test at idle.
- The following may be displayed on the scan tool screen:
| Tank Leak test | Specified value |
|---|---|
| Test function active Test function is being initiated, please wait Test off Test aborted | Test OK |
- Switch the ignition off.
If the specified result is obtained:
System OK.
If the specified result is not obtained:
- Repeat the tank leak test, switch the ignition off and start the engine again and let run for 15 minutes at idle.
- Switch the ignition off.
If the specified result is again not obtained:
- A leak may be present. Refer to → EVAP System, Checking for Leaks