Fuel Metering Valve - N290-, Checking: Notes

General Description

The Engine Control Module -J623- Regulates The Fuel Metering Valve -N290- Directly At The High Pressure Fuel Pump To Control The Low Pressure Flow Inside The High Pressure Fuel Pump.

Special Tools And Workshop Equipment Required

Multimeter.
Wiring Diagram.
Scan Tool.

Test Requirements

Fuses OK.
Battery voltage OK.
Switch OFF all electrical and electronic accessories.
Vehicles with automatic transmission, ensure the selector lever position is in "P".
Vehicles with manual transmission, ensure the shifter lever position is in "N" with the parking brake applied.
Observe all safety precautions: SAFETY PRECAUTIONS .
View clean working conditions: CLEAN WORKING CONDITIONS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	-- YES: GO TO: Step 2 Fuel Metering Valve - N290-, CHECKING - 2 . -- NO: GATHER more information from customer about the complaint.
2	IGNITION: OFF. DISCONNECT: Fuel Metering Valve -N290- harness connector. CHECK: Fuel Metering Valve -N290- component connector terminals 1 to 2 for resistance. SPECIFIED VALUE: 1.5 - 11 Ω (+/- 0.5 Ω @ approx. 20° C). -- Was Value obtained?	-- YES: GO TO: Step 3 Fuel Metering Valve - N290-, CHECKING - 3 . -- NO: REPLACE: Fuel Metering Valve -N290-. Refer to appropriate service information. GO TO: Step 5 Fuel Metering Valve - N290-, CHECKING - 5 .
3	IGNITION: ON. CHECK: Fuel Metering Valve -N290- harness connector terminal 1 to ground for voltage. IGNITION: OFF. SPECIFIED VALUE: Battery voltage. -- Was Value obtained?	-- YES: GO TO: Step 4 Fuel Metering Valve - N290-, CHECKING - 4 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Fuel Metering Valve - N290-, CHECKING - 5 .
4	REMOVE: Engine Control Module - J623-. Refer to appropriate service information. CHECK: Fuel Metering Valve -N290- harness connector terminal 2 to the Engine Control Module - J623- harness connector T60 / 60 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Was Value obtained?	-- YES: TIP: The Fuel Metering Valve -N290- may fail under loaded operation; please swap a known good Fuel Metering Valve -N290- prior to continuing to the next step. GO TO: Step 5 Fuel Metering Valve - N290-, CHECKING - 5 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5 Fuel Metering Valve - N290-, CHECKING - 5 .
5	Refer To The Final Procedure Below;