Ignition Overview
WARNING: This page is about a different variant/trim than selected.
- Ignition Coil Connector
- 4-pin
- Bolt
- 10 Nm
- 3-Pin Connector
- Camshaft Position Sensor
- Camshaft position sensor -G40- cylinder bank 1
- Camshaft position sensor 3 -G300- cylinder bank 1
- Camshaft position sensor 2 -G163- cylinder bank 2
- Camshaft position sensor 4 -G301- cylinder bank 2
- O-ring
- Replace if damaged
- Coat with clean engine oil
- Bolt
- 20 Nm
- Tightening specifications affect function of knock sensor
- Knock Sensors
- Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
- Knock sensor (KS) 1 -G61- cylinder bank 1
- Knock sensor (KS) 2 -G66- cylinder bank 1
- Removing and installing, refer to KNOCK SENSORS
- Spark Plug
- 30 Nm
- Removing and installing with the Spark Plug removal tool 3122 B.
- Ignition Coil
- Ignition coil 1 with power output stage -N70-
- Ignition coil 2 with power output stage -N127-
- Ignition coil 3 with power output stage -N291-
- Ignition coil 4 with power output stage -N292-
- Ignition coil 5 with power output stage -N323-
- Ignition coil 6 with power output stage -N324-
- Removing and installing, refer to IGNITION COILS
- To remove, use the ignition coil Puller T40039