Lower Intake Manifold With Fuel Rail: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
The following removal and installation procedure is for the left lower section of the intake manifold. The procedure for the other side is identical.
WARNING:
There is a risk of injury because the fuel is under very high pressure.
- Before opening high pressure area of the fuel injection system, fuel pressure must be relieved to residual pressure. Refer to BEFORE OPENING HIGH PRESSURE FUEL INJECTION SYSTEM
- To reduce remaining residual pressure, lay a clean cloth around the connector and carefully loosen connector.
-- Remove the upper section of the intake manifold. Refer to INTAKE MANIFOLD, UPPER SECTION .
-- Disconnect the electrical connector on the fuel pressure sensor -G247- -2-.
-- Remove the union nut -1-.
-- Remove the bolts and nuts -arrows- and remove the lower section of the intake manifold with the fuel rail.
NOTE:
Plug the intake ports of the cylinder head with clean rags.