Test-ID 61 (3D): Purge Flow Monitor
WARNING: This page is about a different variant/trim than selected.
- Connect the diagnostic tester.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 61 ($3D)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 128 ($80) | P0441 | Function Check. | 0 | 4.849% | Refer to DTC P0441 in Additional exhaust regulation . |
| 130 ($82) | Function Check. | 3.5% | |||
| 131 ($83) | Function Check. | 0.04 |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.