Test-ID 162 ($A2): Mis-Fire Cylinder 1 Data
WARNING: This page is about a different variant/trim than selected.
- Connect the diagnostic tester.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 162 ($A2)".
- Select the desired "Test-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information | |
|---|---|---|---|---|---|---|
| 11 ($0B) | P0301 | Burn misfire cylinder 1 average value over 10 driving cycles. | 0 | 65535 (counts) | Refer to DTC P0301 in Ignition system . | |
| 12 ($0C) | P0301 | Burn misfire cylinder 1 during this driving cycle. | 0 | 65535 (counts) | Refer to DTC P0301 in Ignition system . | |
- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.