$3A (58): Fuel Tank EVAP System Leak Test (0.090)
WARNING: This page is about a different variant/trim than selected.
- Connect the diagnostic tester.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 59 ($3B)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 129 ($81) | P0455 | Tank leak test: Large leak. | 700 ms | Refer to DTC P0455 in Additional exhaust regulation . |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.