Operating switch on multi-function steering wheel, removing and installing
WARNING: This page is about a different variant/trim than selected.
Removing
- Remove driver's side airbag unit.
Refer to 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- Remove bolts -3-.
- Unplug the connector -4-.
- Slide operating switch -1- out of airbag unit -2- toward front.
Installing
Installation is the reverse of removal, paying attention to the following:
NOTE:
When installing, make sure the connecting wires of connector -4- are reinserted into the guides.
- Tighten bolts -3- of operating switch to 1.1 Nm.