OBDMID 61 (3D): Tank Vent Valve function check
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "OBDMID 61 ($3D)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 128 ($80) | P0441 | Tank ventilation valve check off % DTEV: Active test Air balance at idle. | 0.01 | 1.999 | Refer to DTC P0441 under Control module and output signals . |
| 130 ($82) | Tank ventilation valve check off %DTEV: Active test Oxygen sensor control deviation in lean direction. | 0.06 | |||
| 130 ($82) | Tank ventilation valve check off %DTEV: Active test Oxygen sensor control deviation in rich direction. | -10.0 | |||
| 130 ($82) | Tank ventilation valve check off %DTEV: Active test Oxygen sensor control deviation in rich direction. | 0.05 | 1.0 | ||
| 130 ($82) | Tank ventilation valve check off %DTEV: Active test Oxygen sensor control deviation in rich direction. | 1.0 | 0.05 | ||
| 131 ($83) | Tank ventilation valve check off %DTEV: Passive test Mixture deviation test. | ||||
| 132 ($84) | Tank ventilation valve check off %DLDP(E_tes) tank vent valve check during initial flush. | ||||
| 133 ($85) | Tank ventilation valve check off %DLDP: (E_tes) Reduction of dropout time when flushing. |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.