OBDMID 36 ($24): Catalyst Monitor Bank 2
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "OBDMID 36 ($24)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 132 ($84) | P0421 | Conversion Capability (storage) Check. | 4096 | 65535 | Refer to DTC P0421 under Control module and output signals . |
| 133 ($85) | 225 | 65535 | |||
| 136 ($88) | Catalytic converter monitoring, Bank 2, Aging value. | 0 | |||
| 137 ($89) | Catalytic converter monitoring, Bank 2, Aging value, short test 46. | 0 | |||
| 138 ($90) | Catalytic converter monitoring accumulated range error, Bank 2 Aging value. | 0 | |||
| 139 ($91) | Catalytic converter monitoring accumulated error, Bank 1 + Bank 2, Aging value. | 0 |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.