Selector Lever Cable, Adjusting
Special tools and workshop equipment required
- Socket and KeyT40031
Procedure
-- Remove the frame for the selector lever boot -A- -arrows-.
-- Move the selector lever into "S".
The clamping screw is only accessible when the selector lever is in "S".
Loosen locking screw approximately 1 turn - do not remove completely.
-- Loosen selector lever cable clamping screw approximately 1 turn using Socket And KeyT40031.
-- Carefully move the selector lever forwards and backwards slightly without shifting to a different selector lever position.
This loosens the selector lever cable.
-- Switch ignition on.
The Two Following Conditions Must be Fulfilled
- The "S" in the "PRNDS" display in the Transmission Range Display -Y6- must be lit.
- The "S" inside the Selector Lever Transmission Range Position Display Unit -Y26- must be illuminated.
Conditions are Not Fulfilled
-- Tighten the clamping screw -arrow- for the selector lever cable in this position using the Socket And KeyT40031.
-- Check the DTC memory and correct any faults using Guided Fault Finding Vehicle Diagnostic Tester.
-- Check the adjustment on the Multifunction Transmission Range Switch -F125-. Refer to Multifunction Transmission Range Switch -F125-, ADJUSTING .
-- After that, adjust the selector lever cable again. Refer to SELECTOR LEVER CABLE, ADJUSTING .
Conditions are Fulfilled
Do not move the selector lever forward or backward while tightening the clamping screw otherwise the adjustment will be incorrect.
-- Tighten the bolt -arrow- on the selector lever cable using the Socket And KeyT40031.
Rest of installation is performed in reverse order of removal.
- Tightening specification. Refer to SELECTOR LEVER CABLE .
-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .