SAE P2xxx DTCs: Transmission

WARNING: This page is about a different variant/trim than selected.

DTC	Error Message	Diagnostic Procedure	Malfunction Criteria and Threshold Value	Secondary Parameters with Enable Conditions	Monitoring Time Length	Frequency of checks, MIL Illum
P2637	Torque management Feedback Signal A	Check the CAN-Bus terminal resistance, Transmission Control Module (TCM) J217 to Engine Control Module (ECM) J623. Refer to → CAN-Bus Terminal Resistance, TCM to ECM, Checking .	CAN message signal error flag, = 1	Ignition, on CAN Bus, OK DME CAN connection, OK	0.5 Seconds	Continuous 2 DCY
P2714	Pressure Control Solenoid D Performance or Stuck off	Check Automatic Transmission Pressure Regulating Valve 4 N218. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	PWM hardware detection, 0 or 100%	Low side and high side FET, activated Power supply, > 8.7 V Voltage drop at FET, = 1 V Solenoid supply, > 9 V	0.05 Seconds	Continuous 2 DCY
P2715	Pressure Control Solenoid D Stuck On	Check Automatic Transmission Pressure Regulating Valve 4 N218. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	PWM hardware detection, 0 or 100%	Low side and high side FET, activated Power supply, > 8.7 V Voltage drop at FET, = 1 V Solenoid supply, > 9 V	0.05 Seconds	Continuous 2 DCY
P2716	Pressure Control Solenoid D Electrical	Check Automatic Transmission Pressure Regulating Valve 4 N218. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	Current higher or lower than threshold, 730 mA EDS output voltage at short to ground or open circuit ~ 0, 5 V smaller than EDS supply voltage Static leakage current flow	Off operation mode	0.05 Seconds	Continuous 2 DCY
P2723	Pressure Control Solenoid E Performance or Stuck off	Check Automatic Transmission Pressure Regulating Valve 5 N233. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	PWM hardware detection, 0 or 100%	Low side and high side FET, activated Power supply, > 8.7 V Voltage drop at FET, = 1 V Solenoid supply, > 9 V	0.05 Seconds	Continuous 2 DCY
P2725	Pressure Control Solenoid "E" Electrical	Check Automatic Transmission Pressure Regulating Valve 5 N233. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	Current higher or lower than threshold, 730 mA EDS output voltage at short to ground or open circuit ~ 0, 5 V smaller than EDS supply voltage Static leakage current flow	Off operation mode	0.05 Seconds	Continuous 2 DCY
P2732	Pressure Control Solenoid F Performance or Stuck off	Check Automatic Transmission Pressure Regulating Valve 6 N371. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	PWM hardware detection, 0 or 100%	Low side and high side FET, activated Power supply, > 8.7 V Voltage drop at FET, = 1 V Solenoid supply, > 9 V	0.05 Seconds	Continuous 2 DCY
P2733	Pressure Control Solenoid F Stuck On	Check Automatic Transmission Pressure Regulating Valve 6 N371. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	PWM hardware detection, 0 or 100%	Low side and high side FET, activated Power supply, > 8.7 V Voltage drop at FET, = 1 V Solenoid supply, > 9 V	0.05 Seconds	Continuous 2 DCY
P2734	Pressure Control Solenoid "F" Electrical	Check Automatic Transmission Pressure Regulating Valve 6 N371. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	EDS output voltage at short to ground or open circuit ~ 0, 5 V smaller than EDS supply voltage Static leakage current flow	Off operation mode	0.05 Seconds	Continuous 2 DCY
P2735	Pressure Control Solenoid "F" Intermittent	Check Automatic Transmission Pressure Regulating Valve 6 N371. Refer to → Automatic Transmission Pressure Regulating Valves, Checking .	PWM hardware detection, 0 or 100%	Low side and high side FET, activated Power supply, > 8.7 V Voltage drop at FET, = 1 V Solenoid supply, > 9 V	0.05 Seconds	Continuous 2 DCY