Diagnostic Mode 07: Check Test Results of Components that are Continuously Monitored

WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostic Mode 07 displays all stored DTCs of emission related components and systems which are continuously monitored.

Test requirements

No DTCs stored in the DTC memory.
Coolant temperature at least 80°C.

Procedure

Connect the diagnostic tester.
Start the engine and run at idle.

NOTE:

If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.

Select "Mode 7: Check test results of components that are continuously monitored".

The number of stored DTCs or "0 malfunctions detected" will be displayed diagnostic tester screen.

Switch the ignition off.
Refer to the following DTC tables for the diagnostic repair procedure:

SAE P0xxxDTCs. → SAE P0xxx DTCs .
SAE P1xxx-DTCs → SAE P1xxx DTCs .
SAE P2xxxDTCs. → SAE P2xxx DTCs .
SAE P3xxxDTCs. → SAE P3xxx DTCs .

SAE U0xxxDTCs, → SAE U0xxx DTCs .

Switch the ignition off.
End of diagnosis.