EVAP Canister System/Leak Detection System Assembly Overview

Bolt, 19 Nm
Cover
- For EVAP canister.
Sealing Piece
Vent Line
- From fuel tank filler tube.
- To remove, press release ring on EVAP canister.
Vent Line
- To Evaporative Emission (EVAP) Canister Purge Regulator Valve - N80-.
- To remove, press release ring on EVAP canister.
- Clipped in on fuel tank.
Air Filter Housing
- For Leak Detection Pump (LDP) -V144-.
- No maintenance schedule.
Nut, 4 Nm
Vacuum Line
- Engine/Leak Detection Pump (LDP).
Cable Tie
- To fasten the vacuum line to bracket for leak detection pump.
Leak Detection Pump (LDP) -V144-
- Component location: In left rear wheel housing behind wheel housing liner.
- Checking: Vehicles with 8-cylinder MPI engine, refer to Leak Detection Pump, 8-Cylinder MPI, Checking .
- Checking: vehicles with FSI engine, refer to Leak Detection Pump, FSI, Checking .
- Removing and installing, refer to Leak Detection Pump .
Electrical Harness Connector
- Black.
Connecting Hose
- Leak diagnosis pump/EVAP filter.
- Pressure side.
EVAP Filter
Connecting Hose
- Leak diagnosis pump/air filter.
Connecting Pipe
- EVAP filter/EVAP canister.
EVAP Canister
- Component location: Bottom of spare wheel well.
- Removing and installing, refer to EVAP Canister .