Input shaft adjustment (air gap), checking
CAUTION:
Do not allow engine to run without filling ATF and do not tow the vehicle.
- ATF filled
- Drive vehicle off hoist.
NOTE:
- On vehicles with air suspension, vehicle lifting mode must be deactivated → 43 - SELF-LEVELING SUSPENSION .
- ATF filled
- Place vehicle on level surface.
NOTE:
- With parking brake released, vehicle may roll forward or backward by itself when in selector lever position "N".
- Start engine.
- Place selector lever in position "N".
- Do not engage parking brake.
- Do not operate brake pedal.
- Press accelerator.
- Vehicle should not be allowed to roll.
If vehicle rolls in selector lever position "N":
- Adjust selector lever cable → 37 - AUTOMATIC TRANSMISSION - CONTROLS, HOUSING
If selector lever cable adjustment is OK but vehicle still rolls in selector lever position "N":
- Input shaft, servicing → Input shaft, servicing with 6 lining discs or → Input shaft, servicing with 7 lining discs
NOTE:
- In this case, input shaft adjustment (air gap) was not performed correctly.
If vehicle does not roll in selector lever position "N" :
The input shaft adjustment with evaluation of air play is OK.
- Carry out ATF flush First test run pass through: under ATF flush