Test-ID 60 ($3C): Fuel Tank EVAP System Integrity/LeakTest (0.20/0.5mm)
WARNING: This page is about a different variant/trim than selected.
- Connect the diagnostic tester.
- Start the engine and run at idle.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 60 ($3C)".
- Select the desired "Test-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 130 ($82) | P0455 | Fuel Tank Leak Test. | 4.5-6.5 S | ---- | Refer to DTC P0455 in Additional exhaust regulation . |
- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure → Mode 03: Interrogating fault memory .
- Switch the ignition off.
- End of diagnosis.