Front door handle, preassembling: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replacement door handles must be painted and pre-assembled prior to installation.
NOTE:
The following list refers to Fig 1.
- Door handle
To assemble:
- Insert spring -4- into mount.
- Insert door handle into mount -3- and push on fulcrum lever -8-.
- Push in pivot pins -5- and -6- and peen with center punch. See PEENING PIVOT PINS .
- Install spring -4-. See CORRECT INSTALLATION POSITION OF SPRING .
- Buffer
- Insert after painting
- Door handle mount
- Spring
- Installation position. See CORRECT INSTALLATION POSITION OF SPRING .
- Grease spring with G 052 745 A3
- Pivot pin
- Pay attention to different pin lengths
- Peening. See PEENING PIVOT PINS .
- Pivot pin
- Pay attention to different pin lengths.
- Peening. See PEENING PIVOT PINS .
- Clip
- Fulcrum lever
- Locking pin
- Installing. See INSTALLING LOCKING PINS .