Test requirements:
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle in unladen state (at curb-weight)
- Proper tire pressures (refer to inflation pressure label on vehicle).
- Correct tread depth (set 1 mm less for each 1 mm of wear)
- Wait until control procedure has been completed (observe compressor run)
- Measure height of vehicle at relevant points (production intake points) relative to ground
Note test requirements when measuring axle in vehicles with level control (1BG) .
Basic setting must be performed if the level control sensor, the entire unit or the control module is replaced.
- Set special tool T40002 to appropriate length. See Fig 1. See APPLICATION OF GROUND DISTANCE DIMENSIONS .