Compressor, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Secure compressor element with flange nuts.
Tightening torque: 23 Nm

Fig 1: Installing Hose -1- And Connector -2- At Compressor (Allroad)
Courtesy of AUDI OF AMERICA, INC.
Secure hose -1 at compressor unit.
Tightening torque: 2 Nm
Connect connector -2- at compressor unit.
Secure shielding piece.
Tightening torque: 10 Nm
NOTE:
- Curved plastic exhaust blow-off line at compressor must not contact shielding piece when installing.
- Lower part of compressor and blow-off valve must not contact shielding piece at insulation material.
- Corrugated tube hoses with electrical wires and intake or blow-off hose of compressor must not contact insulation material of spare wheel cavity.
- Electrical wire for blow-off valve must not be pulled tight.
- Free swinging of the compressor must be ensured.
- Tighten hose at shielding piece.
- Install stabilizer bar. See STABILIZER BAR & BUSHINGS .