Diagnostic Mode 09: Vehicle information
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- For all calibration and immobilizer information. Refer to the EBAHN-Website.
Diagnostic Mode 09 is used to display vehicle specific information, e.g. the different Engine Control Module (ECM) versions.
NOTE:
- Depending on scan tool and protocol used, diagnostic mode 09 and the information provided may be referred to by a different name.
Test requirement
- No DTCs stored in the DTC memory.
Procedure
- Connect the scan tool.
- Switch the ignition on.
- Select "Mode 09: Vehicle information".
- Select the desired "OBDMID".
- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all "OBDMIDs" that may be selected.
| OBDMID | Diagnostic text |
|---|---|
| 02: | Vehicle identification number e.g. |
|
|
| 04: | Calibration identification e.g. |
|
|
|
|
| 06: | CVN (check sum) e.g. |
|
|
|
- Switch the ignition off.
- End of diagnosis.