LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2007 >> A4 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (1.8L - Engine Controls - On Board Diagnostic (OBD), Generic Scan Tool Engine Code(S): AMB) >> Generic Scan Tool >> Mode 2: Checking operating conditions >> Final procedures

Final procedures

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

The following work steps must be performed in the described sequence after the malfunction(s) have been repaired:

  1. - Check DTC memory. See MODE 3: CHECK DTC MEMORY  .
  2. - If necessary, erase DTC memory. See MODE 4: RESET/ERASE DIAGNOSTIC DATA  .
  3. - Generate readiness code. See READINESS CODE, GENERATING  .
    • End diagnosis and switch ignition off.
scientia non olet · About LEMON Manuals