General Diagnosis

WARNING: This page is about a different variant/trim than selected.

Preliminary Check

The following table provides quick links to all instructions in this article.

Preliminary Check. Refer to GENERAL DIAGNOSIS .

Before performing any pin point test or component diagnosis, a preliminary check must be performed.

-- Connect the scan tool.

-- Switch the ignition on.

-- Using the scan tool, check for any stored or related DTC's.

If other DTC's are stored:

-- Repair these DTC's first before performing the following procedure.

If no other DTC's are stored:

-- Using the scan tool, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .

-- Perform a road test to attempt to duplicate the customers complaint.

If the DTC returns:

-- Perform the diagnostic procedure.

If the DTC does not return:

-- The fault is intermittent or a sporadic condition may exist.

-- Check the suspected component, electrical harness and electrical harness connectors for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Perform a road test to verify the repair.

If the DTC returns:

-- Perform the diagnostic procedure.

If the DTC does not return:

The fault may have been the result of a loose electrical connection.

-- Generate readiness code. Refer to READINESS CODE DESCRIPTION .

-- End of diagnosis.