Camshaft Adjustment Valve 1, Checking

Special tools and workshop equipment required 

• Multimeter.
• Wiring diagram.

Test requirements 

• The Camshaft Adjustment Valve 1 -N205- fuse OK.
  Fig 1: Fuses On E-Box In Engine Compartment, Left Side

  Courtesy of AUDI OF AMERICA, LLC
• Motronic Engine Control Module (ECM) Power Supply Relay -J271- OK, checking appropriate SYSTEMS WIRING DIAGRAM.
• Battery voltage at least 12.5 volts.
• All electrical consumers such as, lights and rear window defroster, switched off.
• Vehicles with automatic transmission, shift selector lever into position "P" or "N".
• A/C switched off.
• Ground (GND) connections between engine/transmission/chassis OK.
• Ignition switched off.

Test procedure 

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK 

Start diagnosis 

-- Remove the engine cover with air filter. Refer to Repair information.

-- Disconnect Camshaft Adjustment Valve 1 -N205- electrical harness connector -1-.

-- Using a Multimeter, check the Camshaft Adjustment Valve 1 -N205- for resistance.

Specified value: 5.0 to 8.0 Ω (at approx. 20° C)

If the specified value was not obtained:

-- Replace the Camshaft Adjustment Valve 1 -N205-. Refer to Repair information.

If the specified value was obtained:

Checking voltage 

-- Switch the ignition on.

-- Using a Multimeter, Check the Camshaft Adjustment Valve 1 -N205- electrical harness connector terminal to the Motronic Engine Control Module (ECM) Power Supply Relay -J271- terminal 2/86 for voltage.

-- Switch the ignition off.

Specified value: battery voltage.

If the specified value was not obtained:

-- Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).

-- Check the wiring connection for damage, corrosion, lose or broken terminals.

-- If necessary, repair the faulty wiring connection.

If the specified value was obtained:

Checking wiring 

If the manufacturers test box is being used. Perform the following step.

-- Install the test box. Refer to Repair information.

If the manufacturers test box is not being used. Perform the following step.

-- Remove the Motronic Engine Control Module (ECM) -J220-. Refer to Repair information.

-- Using a Multimeter, Check the Camshaft Adjustment Valve 1 -N205- electrical harness connector terminal 2 to the Motronic Engine Control Module (ECM) electrical harness connector T60 terminal 20 for an open circuit.

Camshaft Adjustment Valve 1 -N205- electrical harness connector terminal	Motronic Engine Control Module (ECM) electrical harness connector T60 terminal or test box socket
2	20

Specified value: 1.5 Ω Max.

If the specified value was not obtained:

-- Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).

-- Check the wiring connection for damage, corrosion, lose or broken terminals.

-- If necessary, repair the faulty wiring connection.

If no malfunction is found in the wiring and voltage supply was not OK:

-- Replace the Motronic Engine Control Module (ECM) -J220-. Refer to Repair information.

-- Install the engine cover with air filter. Refer to Repair information.

Final procedures 

After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
2. If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
3. If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .