Windshield Wipers, Bringing Into Service Position
NOTE:
If the windshield wiper motor is to be run during the work procedure, the hood must be closed, otherwise the voltage supply of the wiper motor will be interrupted.
-- Make sure the wiper blades are not frozen.
-- Briefly switch ignition on and off again.
-- Activate one-touch wiping within 10 seconds.
- The windshield wipers run into service position.
Vehicles with Driver Information System
-- Switch on ignition.
-- Press the Reset button -1- on the windshield wiper switch until the menu display appears.
-- Select the desired menu item by pressing the wiper switch -2- and confirm the respective end position by pressing the Reset button
| Adjusting | ||||
| Wiper | ||||
| Front | ||||
| Service Position | ||||
- The windshield wipers run into service position.
All Vehicles
-- Turn off the ignition.
CAUTION:
Risk of damaging the hood by running the wipers back in basic position.
- Do not drive a vehicle with windshield wiper arms folded up.
- The windshield wipers automatically go back into their rest position when the wiper switch is activated or when driving faster than 6 km/h.