Diagnostic Mode 06: Checking test results of components that are not continuously monitored: Notes
Diagnostic Mode 06 displays the test results of emission related components and systems which are not continuously monitored.
The values of the individual test results must reach the specified value or must be within the min. and max. limits.
Depending on scan tool and protocol used, the information displayed in diagnostic mode 06 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and be referenced by only a number.
Test requirements
- Exhaust system must be properly sealed between the catalytic converter and the cylinder heads.
- No DTCs stored in the DTC memory.
- Coolant temperature at least 80°C.
Work procedure
- Connect the scan tool.
- Start the engine and run at idle.
NOTE:
- If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
- Select the desired "Test-ID" of the component or system that is to be monitored, e.g. "Test-ID 01: Oxygen Sensor Monitor Bank 1 - Sensor 1".
- Select the desired "Test-ID".
The current minimum and maximum values will be displayed on the scan tool screen.
The following table is a numerical list of all "Test-IDs" or "Hex-IDs" that may be selected.
| Test-ID (Hex-ID) | Component or System |
|---|---|
| 01 ($01): TID 01 ($01): Catalytic Conversion (Bank 1) under Diagnostic Mode 06: Checking test results of components that are not continuously monitored | Catalytic Conversion (Bank 1) |
| 02 ($02): TID 02 ($02): Oxygen Sensor Bank 1- Sensor 1 under Diagnostic Mode 06: Checking test results of components that are not continuously monitored | Oxygen Sensor Bank 1- Sensor 1 |
| 03 ($03) TID 03 ($03): Secondary Air Injection (AIR) System under Diagnostic Mode 06: Checking test results of components that are not continuously monitored | Secondary Air Injection (AIR) System |
| 05 ($05): TID $05 (05): Tank Ventilation System, Tank Vent Valve Function under Diagnostic Mode 06: Checking test results of components that are not continuously monitored | Tank Ventilation System, Tank Vent Valve Function |
| 05 ($05): TID $05 (05): Tank Ventilation System, Tank Leak Test under Diagnostic Mode 06: Checking test results of components that are not continuously monitored | Tank Ventilation System, Tank Leak Test |