Work procedure

• Connect diagnostic tester. See Connect diagnostic tester  .
• Start engine and let run at idle for at least 15 minutes.
• In diagnostic function "33 - OBD", select "Mode 6: Check test results of components that are not continuously monitored".
• Select the "Test-ID 03: Secondary Air Injection (AIR) system"
• Check specified values at idle.
  SECONDARY AIR INJECTION (AIR) SYSTEM SPECIFICATION
  
  

  Secondary Air Injection (AIR) system	Specification (1)
  Bank 1	min: 24,000
  (1) Control module internal calculated value

• End diagnosis and switch ignition off.

If the specified values are not reached:

• Check secondary air system for proper seal. See SECONDARY AIR INJECTION (AIR) SYSTEM, CHECKING FOR PROPER SEAL .
• Check Secondary Air Injection (AIR) Pump Motor -V101-. See CHECK VOLTAGE SUPPLY OF THE SECONDARY AIR INJECTION (AIR) PUMP MOTOR .