Work procedure

Connect diagnostic tester. See Connect diagnostic tester .
In diagnostic function "33 - OBD", select "Mode 2: Check operating conditions."
Select the desired operating condition via the following table according to the PID (Parameter Identification), e.g. "PID 05: Coolant temperature".
NOTE: Measuring values of Engine Control Module (ECM) are displayed under "10 - Engine electronics" and measuring values of Transmission Control Module (TCM) are displayed under "1A - Transmission electronics".

MODE 2: PID VALUES

PID⁽¹⁾

Display operating conditions

02:

DTC which triggered the current reception of all control module information

03:

Condition of the fuel system

04:

Calculated load condition value

05:

Coolant temperature

06:

Short time gasoline-air ratio bank 1

07:

Gasoline-air ratio bank 1

12:

Engine rotations per minute (RPM)

13:

Vehicle speed

⁽¹⁾	PIDs that are not relevant are not listed.

If DTCs are displayed in "PID 02":

Repair stored malfunction(s) according to DTC table:
- SAE P0xxx-DTCs. See SAE P0xxx-DTCs .
- SAE P1xxx-DTCs. See SAE P1XXX-DTCS .
- SAE P2xxx-DTCs. See SAE P2XXX-DTCS .